4bt P7100 Injector Lines, 14mm thread both ends

These 4bt P7100 injector lines are for the engines with newer 14mm thread injectors

• Comes with hold down brackets as shown
• Injector & pump end of lines fit the larger 14mm threaded = 19mm wrench needed
• If your injectors are 14mm thread and your intake plenum opening is further towards the back like in 2nd picture, these are the lines for your P7100
• Pump end of lines, fit all p7100 pumps….will not fit the smaller A-pump

• IMPORTANT NOTE:
• You may have to tweak lines slightly, specially the #4 cyl injector line ( use a rag & vise in most cases )
• Will not fit if intake plenum hole is towards the front of engine without bending lines ( customers own liability )
• If you are in doubt on what injectors your engine has….measure the threads
• 14mm thread injectors require a 19mm wrench for line nut
• 12mm thread injectors require a 17mm wrench for line nut